Strap and Belt Loop Foot for Pfaff Coverlock

Inspira     code: 620097196     weight: 0.1Kg

Product Overview

Suits Coverlock 3.0 / Coverlock 4.0

also suits Huskylock s21 / Huskylock s25

Create straps and belt loops easily with the Strap and Belt Loop foot on your coverlock.

Simply place a strip into the foot and the strip is folded automatically and stitched in place.

How to use:

Set the machine for a Coverstitch wide.
Use the default stitch settings. Adjust if needed.
Cut a strip of fabric, 1” (25mm) wide.
Cut the top corner of the strip at a 45-degree angle to form a point.
Insert the cut angle into the guide, the right side of the fabric facing up. Pull the strip through the slot and under the foot. Extend the tail of the strip behind the foot. Use tweezers to feed the strip into the foot if needed.
Snap the Strap and Belt Loop foot onto the machine.
Slide the strip approximately 2” (5cm) behind the foot.
Lower the presser foot. Be sure both raw edges of the strip are turned under before stitching. Sew the first few stitches. Stop and clip the needle threads close to the presser foot and continue sewing.
For even feeding, hold the fabric strip slightly below the first guide in the front of the foot.
Sew at medium speed. Check the fabric as you sew to ensure proper feeding.
Note: Sew the folded fabric strip without additional fabric underneath to create straps and belt loops or sew the folded strip onto another fabric for decorative effects.